SynaptiCAD Tutorials

(TD) 3.4 Move Parameters to Different Signals

(TD) 3.4 Move Parameters to Different Signals

Previous topic Next topic  

(TD) 3.4 Move Parameters to Different Signals

Previous topic Next topic  

A delay, setup, hold, or sample parameter can be moved to a different signal transition by dragging and dropping one of the parameter end-points.

In the Diagram window, select the first delay parameter D0 clicking on it. A selected parameter is surrounded by a rectangle with a solid handle box on either end.

selectFirstDelay

Drag and Drop the black handle the right side of the selection rectangle to the first edge on SIG2 as indicated. If the entire parameter is changing its vertical position, then you clicked on the middle of the parameter instead of a handle box.

firstDelayMoved